Care, Cleaning and Adjustment Guide All-Weatherboard™ · Factory Built to Order · Ships in 10 Days Applies to Designer Solid and Designer Woodgrain Finishes O_DC&M-0722
AFTER INSTALLATION CARE After your cabinets have been installed, wipe down all exteriors with a damp cloth to remove dust. Clean Up: Wash WeatherStrong with water and a soft cloth or sponge. A mild dishwashing liquid can be used if needed. For tougher to clean spots, wash with Simply Green All-Purpose Household Cleaner. A soft bristle brush may be used if needed.
DRAWER REMOVAL MANUAL STEP 1 Fully open drawer and remove contents. STEP 2 With drawer fully opened locate slide tab on left side of drawer box and push up to release. STEP 3 Locate slide tab on the right side of drawer box and push down to release. STEP 4 To re-install, align drawer slides and gently push drawer closed. Locking tabs do not need to be pressed. STEP 5 Open and close drawer several times to ensure proper alignment.
ROLL-OUT TRAY RELOCATION/INSTALLATION In a standard base cabinet there is a location on the inside for the roll-out tray. Indicated by the two sets of pre-drilled holes on the back panel. STEP 1 Put the roll-out tray at the desired area in the base cabinet and pick the same desired height on the opposite side. STEP 2 Once the desired area is reached on both sides attach the roll-out tray on the left and right. STEP 3 Push to lock in place. STEP 4 Roll-out tray is installed.
DOOR POSITION ADJUSTMENT MANUAL HEIGHT Loosen two screws and adjust door to desired position. Re-tighten all screws. SIDE TO SIDE Using a Phillips screwdriver, rotate front screw to move the door to the desired position. DEPTH Using a Phillips screwdriver, rotate back screw to move the door to the desired position. HEIGHT SIDE TO SIDE DEPTH For vertical door adjustment loosen center screw on each hinge. Set door at desired height. Re-tighten each screw.
SHELF PINS Cabinet shelves feature locking shelf pins. To release, simply push in the tab and lift the shelf. DRAWER FRONT ADJUSTMENT If additional adjustment is required, loosen screws and twist drawer front for proper alignment. Tighten screws securely.
