User`s guide

Thermo Top Z / C_________________________________Land Rover
- Replace the hose water hose curvature
180 ° (17/1) on the water inlet of the heating, tilt
down and secure it with a clamp
- Connecting the flexible water pipe (17/1) in water pipe
flexible vehicle (17/2) at the output
motor using a connection pipe 20x15
and 2 clamps
- Connecting the flexible water hose of a curvature of 90 °
(18/3) of flexible water pipe of the vehicle (18/1),
level of the heat exchanger, using a
connecting tube 20x15 and 2 clamps
- Put the flexible water pipe (18/3) on the output
water heating and connect with a hose
Tightening
- Replace the plastic support (18/2) of the vehicle
CAUTION:
During assembly of the non-return valve, to
Note the direction of conduction!
- Disconnect the connector (19/1) from the end of
pipe (19/4) of the expansion vessel
- Insert the check valve (19/3) at the end
the pipe (19/4) (direction of conduction from the engine to
the expansion) and secure with a hose
Tightening
- Secure the vehicle connector (19/1) using
a hose (19/2) and two clamps
10