User`s guide

Thermo Top Z / C_________________________________Land Rover
Pre-assembly of heating
- Shorten the exhaust piping
as shown in Figure 8
- Tighten the bolts (9/1, 2, 3) in the heating
(No 10 Nm) zzzzzzzzzzzzzzzzzzzzzzzzzzzzzz
- Replace the exhaust piping (9/6)
heating and secure it with a clamp
(9/5)
- Train the exhaust piping as
shown in Figure 9 eeeeeeeeeeeeeeeeeeeeeee
- Put two washers (9/4) on the
lower studs (9/3)
Installation of heating
- Move the template (10/1) on the trunk Wheel
as shown in Figure 10 and the position
bore (10/2, 3)
- Make a hole (10/2, 3) 8 mm diameter
in the trunk wheel
- Fold the ends drilled as indicated
Figure 11
7