User`s guide

Thermo Top Z / C_________________________________Land Rover
- Mount the bracket (12/5) on the wheel as safe
shown in Figure 12, using 2 M6x20 screws, 2
washers and 2 nuts collars
- Attach the strap (12/3) at the short ends
support with a screw M6x20 (12/4) and a nut
collar as shown in Figure 12
- Align the support and position the bore (12/2)
on the support rod (12/1)
- Remove again the support and the belt
- Make a hole diameter of 7 mm (12/2)
the support rod
- Mount the bracket (12/5) on the wheel as safe
shown in Figure 12, using 2 M6x20 screws, 2
washers and 2 nuts collars
- Mount the belt (12/3) ends the long
support rod (12/1) with a screw M6x16 (12/2) and
one flange nut
- Insert the heater (13/1) on the bracket and secure
with 3 nuts collars (13/2, 3, 4)
TIP:
Pay attention to the two washers on both
lower studs (13/2)
- Align the bracket with heating belt and
perform the set screw connections
- Replace the harness on heating
- Connect the power supply to the socket Mecanyl
heating through a flexible cable and clamps
clamping
- Leading power and beam Mecanyl
electric metering pump down
8