User`s guide

Thermo Top Z / C_________________________________Land Rover
Positioning relative to the circuit
water and non-return valve
TIP:
Secure all hose clamps with a pitch of 2.0
+ 0.5 Nm!
Recovering the liquid flowing cooling
with an appropriate container!
Install flexible water pipes without twisting!
Below you will find the representation
installing the heating circuit in line
Cooling of the vehicle (Figure 14)
Legend to Figure 14:
1 Expansion
2 Cooling Thermostat
Motor Vehicle 3
4 Circulation pump (heating)
5 Heating
6 Heat exchanger heating (vehicle)
7 Cooler
Cut
- Shorten the contour of the water pipe
flexible two sections as shown in Figure 15:
1 x 40 mm + 180 ° bend (15/1) (input
water heating to the engine output)
1 x 40 mm + 90 ° bend (15/2) (the output
water heating of the heat exchanger
vehicle)
Cut
- Disconnect the water hose flexible vehicle
(16/1) of the engine of the heat exchanger
vehicle with forceps and discarding the support
pipe (keep the pipe support)
- Cut the water pipe flexible vehicle (16/1)
level marks indicated on Figure 16
- Clean the hose (16/1)
9