Product Brochure
Cut the bench support and
seat to length using a knife or
handsaw.
Dry fit the bench. Where the bench parts will make contact with a wall and floor, apply wedi joint sealant in
a continuous 1/2 in. thick bead. Ensure the bead is applied in zig zag fashion to ensure good distribution of
sealant for great contact and adhesion everywhere. Where the a wedi contact surface is greater than 2 inches
wide , use thinset mortar (1/4 x 1/4 inch trowel) instead of wedi joint sealant. Ensure that structure is kept tight
in position until sealant or thinset mortar have initially set. Ensure the wall/floor substrate is appropriate for the
wedi joint sealant or thinset mortar to work.
Bench support and top are connected with continuous 1/2 inch beads of wedi joijt sealant. Firmly press parts
together and against the sealant or thinset adhesive as described in step 2. The seat is pre-pitched by wedi so
water can run off towards the drain, later. The Sanoasa kit comes with 1/8 inch wedi building panel which may
be used to close off an open side of the bench. Install these panels with wedi joint sealant. Cut the panels with
a knife to adjust their shape to that of the bench.
Apply 1/2 inch beads of wedi
joint sealant continuously over
every seam and transition area.
Use a putty knife to smooth
the sealant so it covers 1 inch
of the wedi product on either
side of a seam or transition.
01 02
03
04
You may now start tiling im-
mediately!
05
How to install wedi Sanoasa Benches 1-3
wedi Sanoasa Benches 1-3 offer great design solutions for smaller shower
spaces and can be installed into newly built showers or as retrofits. They fit
right in with wedi Shower Systems and may work in conventional shower sys
-
tems as well.
The benches come in two parts, the top/seat and bench support. You’ll find
wedi Joint Sealant already included in the box and there are additionally op
-
tional accessories in the kit to allow for any sort of special situations you may
run into in a project. There are three models that are available. The difference
between models are the front finish and bench top: quarter round, square or
slanted finish options. Each model can be installed with it’s top section’s front
smoothly aligned with the bench supports front, or have it overhanging the
bench support.
9090