Product Brochure

wedi Fundo Ligno Installation

Before Installation:

 Have extra 2 × 4 blocking installed over bottom plate between studs

along to support wedi Building Panel to shower base transition area.

 After recessing or when system is installed over regular suboor, sub-

oor is stable, even and loadbearing, and meets deection criteria of

maximum L/360 and requirements as per IRC. Wooden or concrete

structural substrates are dry and sufciently loadbearing considering

live and dead load. Wood and Steel framing is sufciently loadbea-

ring, plum and square.

 Floor drain assembly below oor is stabilized, xed and supported in

position, and will not sink under water load.

 Only wedi products (Building Panels, Curb, Joint Sealant and Faste-

ners) are used for wedi Fundo Shower System assembly.

 Installer has received instructions from wedi Technical Sales Staff or is

informed about proper installation methods as described.

 wedi Shower Bases can be cut to size using a skilsaw. The Z notch

channel must be remade and cleaned from sawdust or other possible

contamination.

 Follow applicable state or local plumbing codes requiring specic

and dimensioned waterproofed areas for a shower system or other

wet room installation. Requirements in this manual supersede local

plumbing codes; they extend and are not in conict. wedi Shower

Systems or other wet room installations in which non-wedi product

is also used require specic project recommendations by wedi and

may reduce the extent and installation area of protection offered by

wedi’s warranty.