Use and Care Manual

TROUBLESHOOTING
a WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Starting and running problems
Trouble Cause Remedy
Trimmer fails to operate 1. No power
2. Faulty wall outlet
3. Extension cord damaged
4. Circuit breaker shut off or faulty
1. Check power
2. Use another outlet
3. Check cord, replace
4. Reset or replace circuit breaker
Trimmer operates intermittently
1. Extension cord damaged
2. Loose internal connection
3. Internal wiring defective
4. Trigger defective
1. Check cord, replace
2. Call an authorized service center
3. Call an authorized service center
4. Call an authorized service center
Trimmer line problems
Trouble Cause Remedy
• Trimmer line not feeding
• Trimmer line too short
• Trimmer vibrates
Automatic trimmer line feed not working Manually feed out trimmer line
Trimmer line not visible Remove spool cap and spool, free trimmer line
and re-install spool and spool cap.
Manual trimmer line feed not working Rewind trimmer line to remove crossed loops.
Check that trimmer line is in correct section of
spool.
Continuous clattering noise Motor not reaching full speed before use Allow the motor to reach full speed before use
Too much trimmer line fed out Rewind trimmer line
Trimmer line cutter missing Replace trimmer line cutter
Trimmer line snaps continuously Incorrect trimming technique Only use tip of trimmer line to trim
TECHNICAL DATA
WE10T
Rated voltage 120V~60Hz
Rated power 288 W
Cutting diameter 23 cm (9 in)
Trimmer line diameter Ø1.6 mm (0.065 in)
Unloaded speed 11,280-12,720 min
-1
(RPM)
Weight 1.8 kg (4.0 lb)
Protection class
/ II
SERVICE PARTS
591048301 Spool and trimmer line complete
Environmental protection
• Waste electrical products should not be disposed of with household waste.
• Please recycle where facilities exist.
• Check with your local authority or retailer for recycling advice.