User`s manual

MW500 | 27

Powering up and Start-up

- English -

5.3 START-UP

5.3.1 Start-up (using Superdrive and default circuit configuration)

When there is no possible to use the HMIR to start-up the drive, it is possible to use the

Superdrive configuration software for parameters setting and default circuit configuration

for start-up, as shown in figure 5.3.

GND

Shield

S1 S2

S3 S4

1 3 5 7 9 11 13 15

2 4 6 8 10 12 14 16

DI1

DI2

DI3

DI4

+24 V

DO1-NO

AO1

GND

AI1

+10 V

DO2

A(-)

B(+)

DO1-C

DO1-NC

Figure 5.3: Default circuit configuration

For default configuration the commands of the drive are the following:

Table 5.1: Default functions configurations

Function DIx

Run/Stop DI1 (S1)

FWD/REW DI2 (S2)

Reset DI3 (S3)

LOC/REM DI4 (S4)

Speed reference is set via knob reference.