User`s manual

28 | MW500
Powering up and Start-up
- English -
5.3.2 STARTUP Menu (Using Remote Keypad (HMIR))
The start-up is explained in a very simple way, using the programming features with the
existing parameter groups in the menus STARTUP and BASIC.
After the hardware pre-configuration, the drive will operate with a different control type.
5.3.2.1 V/f Control Type (P0202 = 0)
Seq Indication on the Display / Action Seq Indication on the Display / Action
1
6
 Monitoring mode.
 Press the key ENTER/MENU to enter 1st
level of programming mode.
 If necessary, modify the content of “P0401 –
Motor Rated Current”.
 Press the key  for the next parameter.
2 7
 The PARAM group is selected, press the
keys  or  until selecting the STARTUP
group.
 If necessary, modify the content of “P0402 –
Motor Rated Speed”.
 Press the key  for the next parameter.
3 8
 When the STARTUP group is selected
press the key ENTER/MENU.
 If necessary, modify the content of “P0403 –
Motor Rated Frequency”.
 Press the key  for the next parameter.
4 9
 If necessary, press ENTER/MENU to
modify the content of “P0202 – Control
Type” for P0202 = 0 (V/f).
 To end the Start-up routine, press the Key
BACK/ESC.
 To return to the monitoring mode, press the key
BACK/ESC again.
5
 When the desired value is reached, press
ENTER/MENU to save the modification.
 Press the key  for the next parameter.
Figure 5.4: Sequence of the Start-up group for V/f control