User`s manual

30 | MW500
Powering up and Start-up
- English -
Seq Indication on the Display / Action Seq Indication on the Display / Action
11 16
 If necessary, modify the content of “P0403 –
Motor Rated Frequency”, or press the Key 
for the next parameter.
 At the end of the Self-Adjustment, the value
of P0408 automatically returns to “0”, as
well as the Status of “RUN” and “CONF”
are cleared.
 Press the key  for the next parameter.
12 17
 If necessary, modify the content of “P0404 –
Motor Rated Power”, or press the key  for
the next parameter.
 The result of Self-Adjustment is the value
in ohms of the motor stator resistance
shown in P0409.
 This is the last parameter of the Self-
Adjustment of the VVW control mode.
Press the key  to return to initial
parameter P0202.
13 18
 If necessary, modify the content of “P0407 –
Motor Rated Power Factor”, or press the key
 for the next parameter.
 To exit the STARTUP menu, just press
BACK/ESC.
14 19
 At this point, the HMIR shows the option to do
the self-adjustment. Whenever possible, perform
the self-adjustment. Thus, to activate the self-
adjustment, change the value of P0408 to “1”.
 Through the keys  and , select the
desired menu or press the key BACK/ESC
again to return directly to the monitoring
mode of the HMIR.
15
 During the Self-Adjustment the HMIR will
simultaneously indicate the status of “RUN”
and “CONF”. And the bar graph indicates the
progress of the operation.
 And the bar graph indicates the progress of
the operation. The Self-Adjustment can be
interrupted at any time by means of the key .
Figure 5.5 (cont.): Sequence of the Start-up group for V V W control