User`s manual

MW500 | 31
Powering up and Start-up
- English -
5.3.3 Menu BASIC – Basic Application
Seq Indication on the Display / Action Seq Indication on the Display / Action
1
6
 Monitoring mode. Press the key ENTER/MENU
to enter the 1st level of the programming mode.
 If necessary, modify the content of “P0133 –
Minimum Speed”.
 Press the key  for the next parameter.
2 7
 The PARAM group is selected, press the
keys  or  until selecting the BASIC group.
 If necessary, modify the content of “P0134 –
Maximum Speed”.
 Press the key  for the next parameter.
3 8
 When the BASIC group is selected press the
key ENTER/MENU.
 If necessary, modify the content of “P0135 –
Maximum Output Current”.
 Press the key  for the next parameter.
4 9
 Basic Application routine is started. If
necessary, modify the content of “P0100 –
Acceleration Time”.
 Press the key  for the next parameter.
 To end the Start-up routine, press the key
BACK/ESC.
 To return to the monitoring mode, press the
key BACK/ESC again.
5
 If necessary, modify the content of “P0101 –
Deceleration Time”.
 Press the key  for the next parameter.
Figure 5.6: Sequence of the Basic Application group