User`s manual

Appendix C
Appendix C
MW500 | 49
Wall Mounting Instructions
Step Action Step Action
1 3
 For wall mounting, use the adaptation plate
accessory.
 Use a cable gland to install the input power
supply (X1 terminal block) and output
motor wire (X2 terminal block). If necessary
connect the PTC terminals to XC5 (PTC
connector).
2 4
 Fix the plate with the motor seal and 10
stainless steel screws in the rear of the drive.
 Close the drive and don’t forget to connect
the ground plug to the front cover.
Figure C.2: Wall mounting instructions