Operation Manual

8
6. Grease an M10 x 165mm Bolt (50). Attach the
Backrest Frames (16) to the Frame (1) with the
Bolt, two M10 Washers (55), and an M10
L
ocknut (42). Set the end of the Backrest Post
(15) in one of the slots in the Frame. Do not
o
vertighten the Locknut; the Backrest
Frames must pivot easily.
See step 5. Tighten the M10 Locknut (42) and
the four M6 x 40mm Screws (51). Do not over-
tighten the Locknut; the Backrest Post (15)
must pivot easily.
7. Attach the Weight Tube (24) to the Leg Lever
(5) with an M8 x 70mm Bolt (46), a Weight
Tube Spacer (41), two M8 Washers (49), and
an M8 Locknut (36). Then, press a 25mm
Round Outer Cap (29) onto the Weight Tube.
Grease the barrel of an M10 x 77mm Bolt Set
(47). Attach the Leg Lever (5) to the Front Leg
(4) with the Bolt Set. Make sure that the barrel
of the Bolt Set is inserted through both
sides of the bracket on the Front Leg.
6
7
16
1
42
15
Slot
55
50
55
4
47
47
Grease
Bracket
5
36
49
49
29
41
46
24
Grease
8. Insert the Long Pad Tube (56) into the bracket
on the Front Leg (4). Slide two Foam Pads (22)
onto the Pad Tube, and then press two Pad
Caps (23) into the Foam Pads.
Repeat this step with the two Short Pad
Tubes (21) and the Leg Lever (5).
8
23
23
4
5
22
22
56
21
21
Bracket