Instructions

Detailed descriptions of I/O modules | Digital counter module UR20-1CNT-100-1DO
145Manual u-remote1432790000/03/02.2014
Bus
24 V
CH0ACH0BOutResetLatchGate
UR20-1CNT-100 DO - Counter operation through parameter\signal evaluation\rotary transducer xxx
Parameter:
cancel/interrupt internal gate counter function
I/O image setting value integer 32
Parameter: end value integer 32
Parameter: counter function continuous = open
Parameter: load value integer 32
Control word „Set SW gate“
Control word „Load setting value“
Parameter: HW gate deactivated: SW gate only activated: SW gate and HW gate with 24 V
Parameter:
reset -disabled -high level -rising edge -1-time rising edge
Control word „Load setting value“
Counter
Latch
Alarms
Counting value Latch Status word Time stamp Alarm for diagnostic messages
Filter *
Filter *
Filter *
Parameter pulse duration
Filter *
Filter *
=
&
≧
Parameter: function never ≤ comparison value ≥ comparison value = comparison value
I/O image: Comparison value Integer 32
=
Control word „Activate reset mode“