Instructions

Detailed descriptions of I/O modules | Digital counter module UR20-2CNT-100
161Manual u-remote1432790000/03/02.2014
CH0ACH1ACH1B CH0B
Parameter: load value K2 integer 32
Reset: flags overrun, underrun, comparison, end value, CCTRL I bit 6
Parameter:
load value K1 integer 32
Reset: flags overrun, underrun, comparison, end value, CCTRL II bit 6
2CNT100 – Counter operation through parameter\signal evaluation\ pulse/direction (A/B)
Filter * Filter *
SW gate reset CCTRL II bit 2
SW gate reset CCTRL II bit 10
SW gate set CCTRL I bit 2
SW gate reset CCTRL I bit 10
Parameter: cancel/interrupt internal gate 0 counter function
Parameter: counter function internal gate 1 cancel/interrupt
Parameter:
counter function K1 continuous = open
Parameter: counter function K1 continuous = open
Parameter: end value K1 integer 32
Parameter:
comparison value <= comparison value >= comparison value =
Parameter: end value K0 integer 32
Parameter: comparison value <= comparison value >= comparison value =
CCTRL II
bit 1 set bit 9 reset
CCTRL II
bit 1 set bit 9 reset
I/O image setting value K1 integer 32
Load setting value CCTRL II bit 5
I/O image setting value K1 integer 32
Load setting value CCTRL II bit 5
Counting value 1/2 Status word 1/2 Time stamp Alarm for diagnostic messages
Bus
24V
parameter K1
Set comparison bit
Counter Counter
Set comparison bit
parameter K0
Alarms
>1
=
>1
=
=
=