Overview of Primary Product

Boiler Model
Number
Flue Collector Hood(s)
(from left side of boiler)
LGB-4 4 ---
LGB-5 5 ---
LGB-6 A ---
LGB-7 B ---
LGB-8 C ---
LGB-9 D ---
LGB-10 E ---
LGB-11 F ---
LGB-12 G ---
LGB-13 BB
LGB-14 CB
LGB-15 CC
LGB-16 DC
LGB-17 DD
LGB-18 ED
LGB-19 EE
LGB-20 FE
LGB-21 FF
LGB-22 GF
LGB-23 GG
Part Number 550-141-186/0914

s)NSTALLATIONs3TART5Ps-AINTENANCEs0ARTS

See Figure 13 — single base shown.
Refer to the
table below, for proper arrangement.
 !SSEMBLEBOLTWASHERANDNUTTOSECTIONJOINT
2. Apply retort cement for gas-tight seal.
*-
Flue collector hood assembly and sealing the boiler
Gas-tight seal
2e

Hood must be sealed gas-tight to prevent possibility of flue gas spillage and
carbon monoxide emissions, causing severe personal injury or death.
 -OUNTHOODONSECTIONASSEMBLY&ASTENWITHWASHERSANDNUTS
Apply retort cement between bottom of sections and top of base assembly. See
Figure 13.
Sealing the
boiler
Boiler must be sealed gas-tight to prevent possibility of flue gas spillage and
carbon monoxide emissions, causing severe personal injury or death.