Specifications

WELL mPBX-U110R Administrator's Guide
Page38
The Caller ID (CID) string will be used when this user calls another internal user.
2) Voicemail
·Enable Voicemail
Check this box if the user should have a voicemail account.
·Voicemail Access PIN #
Voicemail Password for this extension, i.e. ‘1234’.
3) Mail Setting
·Enable Send Voicemail
Once enabled, the voicemail will be sent to the belowemail address as an
attachment.
·Send Voicemail to Email Address
This option defines whether or not voicemails/Fax is sent to the Email address
asan attachment.
Note: Please ensure that all voicemail settings are properly configured on the
System Settings -> Voicemail Settings page before using this feature.
4) Flash
·Hook Flash Detection
Sets the amount of time, in milliseconds, that must pass since the last
hook-flash event received by mPBX before it will recognize a second event. If a
second event occurs in less time than defined byHook Flash Detection, then
mPBX will ignore the event. The default value of Flash is 1000 ms, and it can be
configured in 1ms increments.
5) Group
·Pickup Group
If this extension belongs to a pickup group, any calls that ring this extension can
be picked up by other extensions in the same pickup group by dialing the Call
Pickup feature code (default *4).
Note: *4 is the default setting, it can be changed under Feature Codes ->
General -> Call Pickup.
6) Call Duration Settings
Setup the max cull duration for every call of this extension, but it’s only valid for
outbound calls. And if enter ‘0’ or leave this blank empty, the value would be
equal to the max call duration configured in the Option Settings page.
Note: This setting will not be valid for internal calls.