Specifications

WELL mPBX-U110R Administrator's Guide
Page56
Set the trunk name
·Signaling
PRI-NET, PRI-CPE,MFC/R2,SS7
·Mode Type
E1 / T1 / J1
·Switch Type
national: National ISDN type2 (common in the US)
ni1: National ISDN type 1
dms100: Nortel DMS100
4ess: AT&T 4ESS
5ess: Lucent 5ESS
euroisdn: EuroISDN
qsig: Minimalistic protocol to build a "network" with two or more PBX of different
vendors!
·PRI Dial Plan
Sets an option required for some (rare) switches that require a dial plan
parameter to be passed. This option is ignored by most PRI switches. It may be
necessary on a few pieces of hardware. This option can almost always be left
unchanged from the default.
·Reset interval
Sets the time in seconds between restart of unused channels. Some PBXs don't
like channel restarts. so set the interval to a very long interval e.g. 100000000
or 'never' to disable *entirely*. If you are in Israel, the following is important:
As Bezeq in Israel doesn't like the B-Channel resets happening on the lines, it is
best to set the reset interval to 'never' when installing a box in Israel. Our past
experience also shows that this parameter may also cause issues on local
switches in the UK and China.
·PRI Local Dial Plan
Sets an option required for some (rare) switches that require a dial plan
parameter to be passed. This option is ignored by most BRI switches. It may be
necessary on a few pieces of hardware. This option can almost always be left
unchanged from the default.
·Over Lap Dial
Define whether mPBX can dial this switch using overlap digits. If you need Direct
Dial-in (DDI; in German "Durchwahl") you should change this to yes, then mPBX
will wait after the last digit it receives.