User manual

6-10 WXMP/WXMT
4 Device description
4.1 Soldering iron WXMP
The WXMP is a powerful 40 W (55 W with RT 11) fine soldering iron
with integrated heating system in the soldering tip. Thanks to a plug-
in system, the soldering tip can be changed without tools.
The WXMP is equipped with a usage detector and can be
automatically switched to standby mode or switched off when not in
use. For details of setting the standby temperature and the switching
times, please refer to the operating instructions of the WX supply
unit in use.
Note The WXMP soldering iron by Weller may only be used with Weller
WX supply units.
4.2 Desoldering tweezers WXMT
The WXMT desoldering tweezers by Weller have been developed
for the re-working and repair of electronic SMD precision tools. The
soldering/desoldering tip set can be replaced easily and quickly
without tools. The tips are pre-calibrated and require no further
alignment. The built-in heating elements (2 x 40 W) ensure that the
desired soldering tip temperature is reached very quickly and
precisely. The WXMT desoldering tip comes equipped with a usage
detector and can be automatically switched to standby mode or Off
when not in use. For details of setting the standby temperature and
switching times, please refer to the operating instructions of the WX
supply unit in use.
Note The WXMT desoldering tweezers may only be operated with WX
supply units
4.3 Technical data
Temperature range 100°C - 450°C (212°F - 850°F)
Tool cable Silicone rubber, heat resistant
Heating element
Senso
r
Heating wire integrated in tip cartridge
Thermocouple integrated in tip cartridge
WXMP
Heating output 40 W (55 W with RT 11)
Voltage (heater) 12 V
Heat-up time (approx.) 3s (50°C to 380°C) (120°F to
660°F)
Connection 6 pin connector, polarity protected with
lock
Weight 26 g incl. tip cartridge without cord
Tip type
Supply unit
RT series
Weller WX stations