Installation & Assembly

Undermount Stainless Steel Sinks

Vitreous China Lavatories

Installation Guide

NOTE:

Due to the nature of undermount installation, Wells Sinkware (Wells)

recommends that Wells undermount sinks be installed by professional installers.

The templates are only a guide. Wells strongly recommends the physical

presence of the sink when countertop is cut.

For Komponents Series multiple bowl configurations, a minimum distance of 2-

1/4'' (57 mm) is required between the bowls. Any additional required support

should be determined by the countertop supplier.

For replacement installations, make sure the existing cutout is the same size or

smaller than the cutout for the new sink.

The number of mounting clips included with your sinks may vary. Use all the

clips provided with the sink.

Allow the silicone caulk to cure following the manufacturer's instructions. All

information in this manual is based on the latest product information available at

the time of publication. Wells reserves the right to make revisions in the design

of products without notice.

Important Information

CAUTION: Stainless Steel Sink may have sharp edges. Handle with care.

1. Wells undermount sinks can be installed in three different ways in terms of the

amount of reveal of the sink flange from the countertop cutout opening (see

Undermount Reveal Options on Page 66). If you want the sink installed

differently from what the template offers, make sure to tell your fabricator your

preference.

PAGE 1
Installation Guide Undermount Stainless Steel Sinks Vitreous China Lavatories Important Information CAUTION: Stainless Steel Sink may have sharp edges. Handle with care. NOTE: Due to the nature of undermount installation, Wells Sinkware (Wells) recommends that Wells undermount sinks be installed by professional installers. The templates are only a guide. Wells strongly recommends the physical presence of the sink when countertop is cut.
PAGE 2
. Verify cabinet clearance. Use Wells recommended cabinet size. Position template at desired location on the countertop allowing necessary space for the sink to fit into the cabinet, and enough room on the countertop for clips, faucet, and soap dispenser, etc. 3. Choose the right fastener (not provided) for the countertop material.
PAGE 3
Mounting Style Options Wells sinks can meet a range of mounting needs. These fall into 4 specific categories as follows. In the case of undermount installation, there are 3 options on the amount of reveal of the sink flange from the countertop cutout opening. Mounting Styles AC Above Counter Sink sits completely on top of the countertop. PR Partial Recess Sink sits partially recessed into the countertop. TM Topmount Sink drops into the opening with the flange mounted on top of the countertop.