Use and Care Manual

4212 WENPRODUCTS.COM

Assembly

and

adjustments

(continued)

Note: Make sure there is enough clearance to allow the table to rotate around the column. The collar must

sit loosely over rack and not angled on the column. To avoid column or collar damage, only tighten the set

screw enough to keep collar in place (Fig. 3).

7. Insert the table support crank handle (9) into the worm gear

shaft on the side of the table support (8). Make sure the set

screw (10) is aligned on the flat of the shaft and as close to the

table support as possible. Tighten the set screw (Fig. 7).

8. Position the table in the same direction as the base, and tighten

the column lock handle (11).

Drill press head to column (Fig. 6)

1. Lift the drill press head assembly (1) carefully and place the

mounting hole of the drill press head onto the top of the

column (2). Make sure the head is seated properly on the

column.

2. Align the direction of the drill press head to the direction of

the base and the table.

3. Tighten the two set screws (3) using an Allen wrench.

Feed handles (Fig. 7)

1. Insert the three feed handles (1) into the threaded openings on

the feed hub (2).

2. Manually tighten handles into openings.

Note: When using the drill press, one or two of the feed

handles may be removed if an unusually-shaped

workpiece interferes with handle rotation.

Fig. 5

Fig. 6

Fig. 7