Use and Care Manual

4212 WENPRODUCTS.COM

Assembly

and

adjustments

(continued)

Speed handle (Fig. 8)

1. Insert the feed handle (1) into the threaded opening on the speed

hub (2).

2. Manually tighten handle into opening.

Warning: Do not change speed without turn on the machine.

Mount the drill press (Fig. 9)

The drill press must be securely fastened through the mounting holes (1)

to a stand or workbench with heavy duty fasteners. This will prevent

the drill press from tipping over, sliding, or walking during operation.

IMPORTANT: If the stand or workbench has a tendency to move

during operation, fasten the workbench securely to the floor.

Chuck adjustments

Install the chuck (Fig. 10)

1. Inspect and clean the taper hole in the chuck (1) and the spindle.

Remove all grease, coatings, and particles from the chuck and

spindle surfaces with a clean cloth.

2. Open the chuck jaws by manually turning the chuck barrel

clockwise. Make sure the jaws are completely recessed inside the

chuck.

3. Insert the chuck arbor (2) into the opening at the top of the chuck (1).

4. Seat the chuck and chuck arbor on the spindle by placing a block of wood (not included) under the chuck (1)

and tapping the wood with a hammer (not included) or tap the chuck with a rubber mallet (not included).

CAUTION: To avoid damaging the chuck, make sure the jaws are completely recessed into the chuck. Do

not use a metal hammer to drive the chuck into the spindle.

Remove the chuck

1. Turn the feed handles to lower the chuck to the lowest position.

2. Place a ball joint separator above the chuck and tap it lightly with a hammer to cause the chuck to drop from the

spindle.

Note: To avoid possible damage, be prepared to catch the chuck as it falls.

Fig. 8

Fig. 9

Fig. 10