Use and Care Manual

4212 WENPRODUCTS.COM

Assembly

and

adjustments

(continued)

Table adjustments

Raise or lower the table (Fig. 11)

1. Loosen the support lock handle (1) and turn the crank handle (2) until

the table is at the desired height.

2. Tighten the support lock handle (1) before drilling.

Rotate the table (Fig. 11)

1. Loosen the support lock handle (1) and turn the table around the

column to the desired position.

Note: The rack should rotate around the column with the table support bracket. If the rack binds and will not

rotate, slightly loosen the set screw in the rack collar.

2. Tighten the support lock before drilling.

Tilt the table (Fig. 12)

1. Loosen the bevel lock bolt (under table) with a suitable socket

wrench.

2. Tilt the table to the desired angle, using the bevel scale (1) as a basic

guide.

3. Re-tighten the bevel lock bolt.

4. To return the table to its original horizontal position, loosen the bevel

lock bolt.

5. Realign the table to the 0° setting on the bevel scale.

6. Tighten the bevel lock bolt with the wrench.

Fig. 11

Fig. 12