Use and Care Manual

4212 WENPRODUCTS.COM
14
Assembly and adjustments (continued)
Laser batteries (Fig. 13)
1. Turn off the laser.
2. Press the tab (1) located below the laser switch (2) and lift up the laser
switch cover (3).
3. Insert 2 "AA" batteries in the laser battery compartment.
4. Close the laser switch cover.
Laser line (Fig. 14)
WARNING: Do not stare directly at the laser beam! A hazard may exist if you deliberately stare into the
beam. Please observe all safety rules.
• Never aim the beam at any person or an object other than the workpiece.
• Do not project the laser beam into the eyes of others.
• Always make sure the laser beam is aimed at a workpiece that does not possess reflective surfaces as
the laser beam could be projected into your eyes or the eyes of others.
1. Place a workpiece on the table.
2. Turn the laser switch to the ON position.
3. Lower the drill bit to meet the workpiece. The two laser lines
should cross where the drill meets the workpiece.
4. If the laser needs to be adjusted:
a. Using a 3 mm hex key, turn the laser adjustment set
screws (4) counterclockwise.
b. Rotate the laser light housing (5) until the two laser lines
intersect where the drill meets the workpiece. DO NOT
stare directly at the laser lines.
5. Re-tighten the adjustment set screws (4).
1
2
3
4
5
Fig. 13
Fig. 14