Use and Care Manual

ManualsBrandsWEN ManualsOutdoor Power EquipmentPlate Compactor and Vibratory Asphalt/Soil Plate

ASSEMBLY

In order to best protect the plate compactor while in the package, this product comes with some components

disassembled. Please complete the following assembly step before proceeding to use the plate compactor.

If after reading this section, you are unsure about how to perform any of the steps, please call 800-232-1195 (M-F

8-5 CST)

WARNING: This plate compactor is heavy. Some procedures may require lifting equipment or two

people.

HANDLE ASSEMBLY:

The Plate Compactor is shipped with the lower handle already assembled and attached to the plate.

To complete the handle assembly, loosen the knobs in the middle of the handle and swing the upper handle into

place.

Next, insert the bolt, washer and nut into the hole directly above the plastic knob. Tighten the nut and the plastic

knob.

Repeat the process on the other side of the handle.

PREPARATION



CAUTION: Air cooled engines run hot-

ter than automotive engines. The use of

non-synthetic multi-viscosity oils (5W-30,

10W-30, etc.) in temperatures above 40°

F will result in higher than normal oil con-

sumption. When using a multi-viscosity

oil, check the oil level more frequently

than you would otherwise.

ENGINE OIL RECOMMENDATIONS

STEP 1 - FILL OIL:

The plate compactor is shipped without oil. User must add the

proper amount of oil before operating the plate compactor for the

first time. The oil capacity of the engine crankcase is 20 fl. oz (0.6 L).

Select good quality detergent oil bearing the American Petroleum In-

stitute (API) service classifications SJ, SL, or SM (synthetic oils may

be used). Use the ASE viscosity grade of oil from the following chart

(Fig. 1) that matches the starting temperature anticipated before the

next oil changes.

FILLING CRANKCASE WITH OIL:

1. Make sure the plate compactor is on a level surface. Tilting the

plate compactor to assist in filling will cause oil to flow into engine

areas and will cause damage. Keep plate compactor level!

2. Remove the oil filler/dipstick cap (Fig. 2 - 1) from the engine.

3. Using a funnel, add the appropriate type and amount of oil into

the crankcase. The crankcase is full when the oil level has reached

the second thread from the lip of the opening (Fig. 3, next page).

4. Check for oil leaks. Reinstall oil filler cap before starting engine.

WARNING: This plate compactor may emit highly flammable and explosive gasoline vapors, which can

cause severe burns or even death if ignited. A nearby open flame can lead to explosion even if not directly

in contact with gasoline.

Fig. 1

Fig. 2