Product Manual

ASSEMBLY

Fig. 4

ATTACH THE TOOL HOLDER

1. Flip the garage glider upright, so its sitting on its

wheels.

2. Align the holes on the tool holder (Fig. 4 - 1) with

the holes on the rear of the tool chest.

Note: The flat part of the tool holder should be on the

top.

3. Fasten with two M6 bolts. Use a Phillips-head

screwdriver (not included) to tighten.

TOOL TRAY STRAPS

There are two pre-assembled tool tray straps (Fig.

5 - 1) located on the short sides of the garage glider.

These straps can be used to fold up the tool trays

when not in use.

To fold up:

1. Remove all items from the tool tray. Fold the tool

tray up.

2. Snap the tool tray strap onto the bottom of the tool

tray.

To unfold:

1. Hold the tool tray, unsnap the tool tray strap. Slow-

ly lower the tray.

2. Place tools onto the tool tray, do not exceed 11

pounds evenly distributed.

Fig. 5

SIDE TRAY STRAPS

side

side side

side

items