Use and Care Manual

English - 3
• The product is equipped with an intelligent protection chip, for automatic shutoff
after 20 minutes of continuous work. After automatic shutoff wait 20-30 minutes to
cool the unit before using again. This method is conducive to extending the service
life of the product.
• The product has a current limiting design. When processing harder ingredients,
the motor go into locked-rotor mode and the current will increase. Should the
current exceed 2A, the machine will make a “tick” sound and the motor will shut
down. This protects the motor from over-heating and extends the service life of the
motor.
• If the motor stops automatically due to current limiting protection or locked-rotor
during operation the motor should be allowed to cool. After cooling set the power
switch to “REV” state, and the ingredients should be withdrawn. It is recommended
to use “REV” to clean up the ingredients in the auger before continuing use. This
method is to protect the motor. After cleaning shut the machine and let it cool prior
to using again.
• After use, please wait until the motor and auger stop rotating and make sure that
the power is disconnected before removing the removable parts of the machine.
• Do not use hot water over 176°F/80°C or a microwave oven to clean any part of
your juicer. Parts and materials in contact with food ingredients are in line with
food hygiene certification, clean, hygienic and reliable.
• Do not use steel wool, abrasive cleaner or corrosive liquid (e.g. petrol or acetone)
to wash this product.
• This product is only applicable to individual or home application.
• This product is a Class I appliance. The grounding wire of the socket must be well
grounded.
• If this product needs to be repaired in the course of use, please contact our
Customer Service Department. Be sure not to take apart or repair the product by
yourself to avoid risks and void the warranty.
SAVE THESE INSTRUCTIONS
PARTS