Installation Guide

QHT-1

Hot Tank

FLT-1

Water Filter

Cold Water Supply

for Hot Tank and Cold

Connect to Hot

Water Tank

Connect to

Cold Water Inlet

Mounting Post &

Rubber Hose Inlet

Bottom View of faucet

Installation:

1. Gently straighten supply lines and thread into bottom of faucet. No compound is required;

however, a small amount of silicone seal may be used if desired. Do not over tighten.

2. Place a small bead of silicone seal around the base of the faucet and insert faucet through sink. Using

mounting nut and washer, fasten faucet to sink. Do not over tighten.

3. Attach rubber line to mounting nipple using a nylon pinch clamp.

4. Attach cold water inlet line to cold water supply.

5. Mount Hot water Tank to cabinet wall and hang tank on bracket. Do not plug tank in.

6. Attach cold supply from faucet to corner inlet of tank.

7. Attach adapter to tank outlet and attach rubber hose to tank with the other pinch clamp.

8.Turn on water supply and check for leaks. Operate faucet handles to purge air from the system.

10. Allow tank to come to temperature - empty completely to rinse debris from system.

The faucet will leak until the pressure is equalized. This venting prevents the tank from exploding.