Quick start Guide

Warning

Removing from a Flex Cine Wireless DMX Dimmer

To remove the AC Adapter from the dimmer, hold the release button

located alongside the V-Mount while sliding the AC Adapter out of

the dimmer V-Mount. Then, release the button and store adapter

when not in use.

Operation

• Only for use with the Westcott Flex Cine Wireless DMX Dimmer

• Do not block vents

• Keep dry and away from ﬁre

• Do not submerge in water

• Do not attempt to open or modify

• Do not short terminals

• Do not alter or change V-Mount plate

If the fan is inoperable after all connections are made, remove the

power cord from the wall and AC Adapter, and re-connect.

If the AC Adapter is still inoperable after conﬁrming the power cord

connections are secure, the adapter’s fuse (250V 10A In-Line) may

need to be replaced.

Troubleshooting

Attaching to a Flex Cine Wireless DMX Dimmer

1. Plug one end of the power cord into the bottom of the AC Adapter

and the other end into a wall outlet.

2. Align the V-Mount on the back of the AC Adapter to the V-Mount

on the dimmer, ensuring that the point of the “V” shape on each are

pointed in the same direction.

3. Gently press the AC Adapter against the V-Mount on the dimmer

and slide into place until it clicks. Conﬁrm the connection is secure by

gently attempting to slide the AC Adapter in the opposite direction.

4. Once attached, ensure the Flex Cine Mat is connected and powered

by pressing the toggle switch on the dimmer, which is between the

two units.