User guide

030-300432 Rev. A 100 February 2005
User Guide
To enable VLAN, click on the box adjacent to the VLAN Enable field. A check mark will appear in the box.
Click save to save the settings.
NOTE: For VLAN to function properly, the VLAN ID must be set to a value other than ‘1’ in VLAN
Configuration screen and in the VC 1 Configuration screen when the you are using the Bridge (VLAN Bridge)
protocol. See Advanced WAN section for configuring VC’s (refer to section 13.6.6).
NOTE: If you change the values in the VLAN Configuration screen and click the reset button, the screen will
display the previously set values for the LAN Port you have selected. If you change the settings in this screen, you
must click save to save the new settings.
If you click on save, the following pop-up screen will appear. Click OK in the pop-up screen to allow the new
settings to take effect.