User guide

030-300432 Rev. A 105 February 2005
User Guide
13.6.3 WAN Configuration (Models 328W10, 328W11)
The following screen will be displayed if you select Advanced WAN > WAN from the Configuration menu. If
you change the Bridge Broadcast, Bridge Multicast, or Spanning Tree Protocol configurations in this screen,
click on the save filter settings button to allow these changes to take effect. If you change any of the Status
configurations, a pop-up screen will prompt you to reset the Router. After the Router has been reset, the Status
configurations will take effect. The edit button allows you to change the VC configuration settings of the Router.
Details on the edit button are explained later in section 13.6.4.
NOTE: The actual information displayed in this screen may vary, depending on the network connection established.
If you are using Model 328W10 or Model 328W11, the following screen will be displayed.
WAN PORT
Factory Default = DSLATM PORT
Possible Responses:
DSLATM PORT - Selecting this will enable the Router’s DSL transceiver.
This will disable the WAN Ethernet port and allow the WAN interface to use
the DSL port.
ETHERNET PORT 1 – Selecting this will disable the Router’s DSL
transceiver. This will enable the WAN Ethernet port and allow the WAN
interface to use the UPLINK/E1 Port.
Status Allows you to enable or disable your VC (Virtual Connection)
VPI
Displays the VPI (Virtual Path Indicator) value for a particular VC, which is
defined by your Service Provider.
VCI
Displays the VCI (Virtual Channel Indicator) value for a particular VC,
which is defined by your Service Provider.