User guide

030-300432 Rev. A 116 February 2005
User Guide
13.6.5 Configuring the Router’s Protocol Settings for PPPoE Mode
If you are using Models 7400, 7401 select Advanced WAN > VC from the Configuration menu to configure the
Router’s protocol settings for PPPoE mode. If you are using Models 328W10, 328W11, select Advanced WAN >
WAN from the Configuration menu to configure the Router’s protocol settings for PPPoE mode.
The VC Configuration screen will be displayed. Next, click on the edit button adjacent to any of the existing
‘Enabled’ VC (Virtual Connection) protocols. (Note: The protocol status must display “Enable” to allow edits to its VC
configuration.).
If you clicked edit in the VC Configuration screen, the following VC 1 Configuration screen will be displayed.
Select PPPoE from the options listed in Protocol drop-down arrow. After you have made changes to VC 1
Configuration screen, click the set VC button.
If you click the set VC button, the following pop-up screen will be displayed. Click on OK in the pop-up screen. If
you click on Cancel, the new settings will not be saved. After you click on OK, follow the instructions to reset the
Router, as previously discussed in section 13.6.4.