User guide

030-300432 Rev. A 117 February 2005
User Guide
13.6.6 Configuring the Router’s Protocol Settings for Bridge Mode
If you are using Models 7400, 7401 select Advanced WAN > VC from the Configuration menu to configure the
Router’s protocol settings for Bridge mode. If you are using Models 328W10, 328W11, select Advanced WAN >
WAN from the Configuration menu to configure the Router’s protocol settings for Bridge mode.
The VC Configuration screen will be displayed. Next, click on the edit button adjacent to any of the existing
‘Enabled’ VC (Virtual Connection) protocols. (Note: The protocol status must display “Enable” to allow edits to its VC
configuration.)
If you clicked edit in the VC Configuration screen, the following VC 1 Configuration screen will be displayed.
Select Bridge from the options listed in Protocol drop-down arrow. Next, select a mode from the options listed in
the Mode drop-down arrow, under VC1 – Bridge Settings. After you have made changes to VC 1 Configuration
screen, click the set VC button.