User guide

030-300432 Rev. A 20 February 2005
User Guide
Warning: Your power requirements may differ from those displayed in the following instructions. You must use
only the power adapter provided with your kit.
To network the Router to additional computers in your home or office using a wireless installation, you will need to
confirm the following:
1. Ensure that an 802.11b/g/g+ wireless network adapter has been installed in each PC on your wireless network.
2. Install the appropriate drivers for your Wireless IEEE802.11b or IEEE802.11g adapter.
3. Make sure the SMA antenna connector is loose. Orient the antenna in the proper configuration. Then, tighten
the antenna knob to lock it into place.
4. Connect the power supply cord to the power connector marked 15 VAC on the rear panel of the Router. Plug
the other end of the power supply into a wall socket.
5. Connect the DSL phone cable from the connector marked DSL on the rear panel of the Router to the DSL-
equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must
use the phone cord that was provided with the Router kit.
6. Check to see if the DSL LED is solid Green. If the DSL LED is solid Green, the Router is functioning properly.
7. Check to see if the Router’s Wireless LED is solid Green. This means that the Wireless interface is functioning
properly.
Congratulations! You have completed the Wireless installation for the Router. You must now proceed section 8 to
configure your Router for Internet connection.
Figure 2. Connection via Wireless