User guide

030-300432 Rev. A 22 February 2005
User Guide
6.4.4 Installation via USB (Models 7400, 328W10)
Westell recommends using the Router via Wireless or Ethernet connections. However, if you choose to connect via
USB, you must follow the instructions in this section.
IMPORTANT: The USB installation will not function for Macintosh computers. Macintosh computers
must install via Ethernet connection. See section 6.4.1 for Ethernet installation instructions. Prior to
installing the Router via USB, confirm that the CD-ROM provided with your Router kit is inserted
in your computer’s CD-ROM drive.
Warning: Your power requirements may differ from those displayed in the following instructions. You must use
only the power adapter provided with your kit.
1. Connect the power supply cord to the power connector marked 15 VAC on the rear panel of the Router. Plug
the other end of the power supply into a wall socket.
2. Connect the DSL phone cable from the jack marked
DSL on the rear panel of the Router to the DSL-
equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must
use the phone cord that was provided with the kit.
3. Connect the blue USB cable from the USB connector marked
USB on the rear panel of the Router to
the USB port on the PC. You must now go to section 7 for instructions on installing the USB drivers.
4. Check to see if the DSL LED is solid green. If the DSL LED is solid green, the Router is functioning properly.
5. Check to see if the USB LED is solid green. Solid green indicates that the USB connection is functioning properly.
Congratulations! You have completed the USB hardware installation. You must now proceed to section 8 to
configure your Router for Internet connection.
Figure 3. Connection via USB
!