User guide

030-300432 Rev. A 38 February 2005
User Guide
After you type your account parameters at the User Name screen, the Account ID will be displayed, however, the
Password will be masked for security, as shown below. Click next if you want your account parameters to take
effect. Click reset if you do not want the account parameters to take effect or if you want to retype the parameters.
Type the VPI and VCI values (0 for VPI and 35 for VCI default) you obtained from your Internet service provider.
The actual VPI/VCI values may vary according to your ISP. Click on next.
N
OTE: Depending on your Internet Service
Provider, the VPI/VCI screen may come
pre-configured and it will be displayed here.
In this case, you should not change any
values in this screen. Click on next to go to
the PROTOCOL screen.
VPI = 0
VCI =
35