User guide

030-300432 Rev. A 64 February 2005
User Guide
13.2.1 Configuring UPNP on your Router
Note: To use the UPNP functionality in the Router, your Windows XP operating system must also support UPNP.
Please contact your computer manufacturer to verify that UPNP is enabled in your Windows XP operating system.
To enable UPNP on the Router perform the following steps:
1) Select Services from the Configuration menu.
2) Click the UPNP Enable box in the Service Configuration screen. A check mark will appear in the box.
3) Follow the instructions in the pop-up screens.
4) Click OK to reset the Router.
NOTE: When you are ready to disable UPNP, uncheck the UPNP Enable box in the Service Configuration screen.
If you click the UPNP Enable box in the Service Configuration screen, a check mark will appear in the box, as
shown below.
And the following pop-up screen will be displayed. Click on OK.