User guide

030-300432 Rev. A 98 February 2005
User Guide
Warning Message Check Public LAN DHCP Settings
Start Address is not part of the Subnet Check the value in the DHCP Start Address field
End Address is not part of the Subnet Check the value in the DHCP End Address field
End Address is below the Start Address Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 59 Check the Seconds field at DHCP Lease Time
Minutes must be between 0 and 59 Check the Minutes field at DHCP Lease Time
Hours must be between 0 and 23 Check the Hours field at DHCP Lease Time
If you clicked on OK in the Load new Public LAN configuration? screen, the following pop-up screen will be
displayed. This will allow the modem to be reset and the new configuration will take effect. Click on OK.
If you clicked on OK in the preceding screen, the following screen will be displayed. The Router will be reset and
the new configuration will take effect.
After a brief delay, the home page will be displayed. Confirm that you have a DSL sync and that your PPP session
displays UP. (Click on the connect button to establish a PPP session).
NOTE: Whenever the PPP Status displays DOWN, you do not have a PPP session established. If your Router’s
connection setting is set to “Always On,” after a brief delay the PPP session will be established automatically and
the PPP Status will display UP. If the connection setting is set to “Manual,” you must click on the Connect button
to establish a PPP session. Once the PPP session has been established (PPP Status displays UP), you may proceed
with your Router’s configuration.