Replacement Part List

ASSEMBLY

Before assembling the pressure

washer, review Safety on page 7

and the following safety messages.

CAUTION

Never lift the pressure washer without

assistance. The pressure washer is

heavy and lifting without assistance

could result in personal injury.

Never use the handles as a lifting point

to support the entire weight of the

pressure washer. Only use the handles

to move the pressure washer by lifting

the handles and using the wheels to

move the pressure washer.

Use caution when collapsing the

handles. Hands and ﬁ ngers could get

caught and pinched.

NOTICE

Assembling the pressure washer will require tipping

the unit. Make sure all engine oil and fuel are drained

from the unit prior to assembling.

Once assembled, the wheels are not intended for

on-road use. The wheels are designed for use on this

pressure washer only.

Never tip the pressure washer after it has been fully

assembled and ﬁ lled with oil and fuel.

1. Place pressure washer on a ﬂ at surface.

2. Place a piece of cardboard or other soft material to

tip the pressure washer onto, to protect the frame

paint and prevent the pressure washer from sliding.

Tip the

pressure washer onto the front as shown in

Figure 5.

Figure 5 – Tip the Pressure Washer onto the Front

3. Install the M12 x 105 mm wheel axle ﬂ ange bolt

through the wheel (see Figure 6).

Figure 6 – Installing Outside Serrated Flange Nut

1 - Wheel Axle

Flange Bolt

2 - Serrated Flange

Nut

4. Thread the M12 serrated ﬂ ange nut onto the bolt

with serrated edges facing away from the wheel.

Tighten the nut (see Figure 6).