User Manual

10
INITIAL START-UP
INITIAL START-UP
This series of refrigerators has been fitted with a ‘wet wall’
evaporator which is positioned behind the rear liner. The
rear liner will, at times be wet or appear frosted. This is
normal and demonstrates that the refrigerator is functioning
correctly. This product is designed to operate on a power
supply of 220/240 volts 50Hz. Connect to a separate
power point with a correctly earthed three pin socket. Do
not use double adaptors.
CONTROLLING THE TEMPERATURE IN YOUR REFRIGERATOR
Refrigerators work by transferring heat from the food inside
to the outside air. This operation makes the back and sides
of the refrigerator (particularly at start-up) feel warm – which
is normal. Make sure you fully close the refrigerator door
after loading or removing food. If the door is left partially
open, a heavy frost will coat the inside of the ice box.
Ensure shelves are pushed back completely to prevent them
holding the door open.
If the unit is unplugged, power lost or turned off, you must
wait 3 to 5 minutes before restarting the unit. If you attempt
to restart the unit before this time delay, the refrigerator will
not start.
When the thermostat is turned to it’s lowest setting and past
the point of resistance, the appliance will not operate.
WARNING
Power is still supplied to the appliance
This series of refrigerator has been fitted with a hidden
“wet wall” cooling plate, which is positioned behind
the rear liner wall of the food compartment.
The rear liner may, at times, appear frosty or wet.
This is normal and demonstrates that the refrigerator
is functioning correctly.
Turn the control knob clockwise to turn the appliance on.
Rotating clockwise will make the appliance colder.
For all models, ‘Less Cold’ corresponds to the warmest
temperature while ‘Colder’ the coldest.
Adjusting the control knobs of WIM1000 amd WIM1200
will adjust the temperature in both the fridge and freezer
compartments.
When the ambient room temperature is 16°C, a setting
of half way between ‘Less Cold’ and ‘Off’ recommended.
When the ambient room temperature is 25°C, a setting
of half way between ‘Off’ and ‘Colder’ recommended.
When you change temperature settings, make small
adjustments and wait 24 hours before assessing whether
you need to make further changes.
Models WIM1200, WRM1300
and WRM2400
Model WIM1000
Less Cold
Less Cold
Off
Off
Colder
Colder
Condensation caused
by the cooling plate