User Manual

30 CARE AND CLEANING
Releasing the grill element
WARNING
WARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
Retaining wire models - The upper grill element is secured
with a hanger clip which can be removed to help clean
the oven cavity ceiling. To remove the hanging clip push
the sides of the clip in the direction of the arrows. After
cleaning, raise the grill element and secure clip back
into position.
NOTE: Diagram shows a grill in oven model. The
procedure is the same for separate grill models which use
the same hanger clip in the grill compartment.
Retaining clips models - The upper grill element is
secured with 2 clips which can be removed to help clean
the oven cavity ceiling. To disengage the clips, push the
edge of the clip towards back of the oven as shown
below. After cleaning raise the grill element and secure
clips back in position.
Rotating latch models - rotate latch 180
o
and the grill
element will drop down freely. After cleaning, raise the
grill element and secure by rotating the latch back 180
o
.
Cleaning the triple glazed oven door
(on selected models)
WARNING
CAUTION
Do not lift the door by the handle. Rough handling will
cause glass to break.
Removing the oven door
TIPS & INFORMATION
IMPORTANT
Your oven is equipped with a door that can be
disassembled in order to clean all the panes of glass.
Remove the door before cleaning.
• Open the door fully to access the hinges then rotate
the ‘stirrups’ on both hinges fully towards the oven.
• Slowly close the oven door until it stops against the
‘stirrups’ (about 45°).
45
CARE AND CLEANING (CONTINUED)