User guide

5. OPERATION WHEATHEART - POST POUNDER
5.2. DRIVES & LOCKOUTS HIGH & HEAVY HITTER AND HIGH & HEAVY HITTER PLUS
26 IM4 R3
..
5.2. DRIVES & LOCKOUTS
This unit can be equipped with a gas motor / PTO driving a hydraulic pump or a
tractor / skid steer loader supplying the hydraulic power to the machine’s
hydraulic valves.
Before performing any maintenance or servicing, ensure that the ignition key is
removed or the power source is locked out, and the post pounder mast is in the
down position.
5.3. START-UP & BREAK-IN
Although there are no operational restrictions on the machine when used for the
first time, it is recommended that the following mechanical items be checked:
BEFORE STARTING:
• Read power unit operational manual.
• Inspect hydraulic hose fittings for leaks. Tighten if necessary, and replace
worn or damaged hoses.
• Inspect hydraulic mount bolts for tightness.
DURING THE FIRST FEW MINUTES:
• Ensure unit is running properly.
• Some air may be trapped in the hydraulic system; slowly activate hydrau-
lic control valves to ensure all air is out of the system.
AFTER OPERATING FOR 1/2 HOUR OR TRANSPORTING:
• Retorque all wheel bolts (if applicable).
• Retorque all fasteners and hardware.
• Check all safety decals are installed and legible. Apply new ones if
needed.
• Check all guards are installed and working as intended.
AFTER 5 AND 10 HOURS:
• Check all hydraulic hoses and fittings for leaks. Tighten fittings where
required, and replace worn or damaged hoses.
• Retorque all wheel bolts (if applicable), fasteners, and hardware.
• Grease all zerks; do not grease plastic slides or mast rails.
WARNING
Shut off and remove key or lock out power
source before inspecting or servicing the
machine.