User guide

5. OPERATION WHEATHEART - POST POUNDER
5.5. SHUTDOWN HIGH & HEAVY HITTER AND HIGH & HEAVY HITTER PLUS
30 IM4 R3
5.5. SHUTDOWN
ENGINE DRIVE MODELS:
1. After completing the job, ensure that the pounder mast is in the lowered
position.
2. Lean the mast back into the transport position. Fully extend hitch cylinder.
3. Reduce engine speed to a low idle to allow motor to cool off.
4. Once motor has cooled down, shut engine off.
PTO DRIVE MODELS
1. After completing the job, ensure that the pounder mast is in the lowered
position.
2. Lean the mast back into the transport position. Fully extend hitch cylinder (if
equipped).
3. Reduce PTO speed and turn off PTO/power source.
SKID STEER / TRACTOR SUPPLIED HYDRAULIC MODELS:
1. After completing the job, ensure that the pounder mast is in the lowered
position.
2. Lean the mast back into the transport position.
3. Place the hydraulic control lever in neutral to shut off flow of oil to pounder
hydraulic valve. Remove key or lock out power source and then install
hairpins on the transport lock.
WARNING
DO NOT let impact head free fall without
pounding a post.
If head must be lowered, shut off and lock out
power source and gently actuate hydraulic
valve to lower head.