Installation Sheet

ManualsBrandsWhirlpool Appliances ManualsFreezersWhirlpool 30 Inch Wide 18 Cu. Ft. All-Freezer with Fast Freeze and LED Lighting

INSTALLATION REQUIREMENTS

The SKT60* Trim Kit provides an integrated appearance when

installing an all-refrigerator and upright freezer side by side.

Plan the Installation

Plan your installation using these instructions in conjunction with

the Use & Care Guides provided with the refrigerator and freezer.

IMPORTANT:

■ For ease in handling and alignment, it is required that 2 people

install the trim kit.

■ Make sure there is enough area, approximately 7 ft (2.1 m) by

10 ft (3.1 m) to assemble parts on the floor.

■ Lay a drop cloth on the floor to cushion the parts and cover

the flooring.

■ These instructions are intended as a general guide only and

do not supersede any national or local codes in any way.

Compliance with all local, state or national codes pertaining to

this type of installation should be determined prior to

installation.

Opening Requirements

Make sure the opening is 74¹⁄₂" (189.2 cm) high by 62¹⁄₈"

(157.8 cm) wide by 24¹⁄₄" (61.6 cm) deep, as shown.

The inner opening dimensions of the installed trim kit will be

61.31" (155.7 cm) wide by 66.85" (189.7 cm) high.

NOTE: It is possible to make the trim kit fit vertical openings that

are less than 74¹⁄₂" (189.2 cm) high. The trim kit can be reduced in

height by 1" (2.54 cm) increments. Each top grille (B) section is 1"

(2.54 cm) in height. For each top grille (B) section that is not used,

1" (2.54 cm) must be cut from the base of both the left-hand (E)

and right-hand (G) side trim pieces.

Tools Needed

Assemble the required tools and parts before starting installation.

Read and follow the instructions provided with any of the required

tools listed here. Proper installation is your responsibility.

Tools Needed

Parts Supplied

Remove the parts from the trim kit package. Make sure all parts

are included.

IMPORTANT:

■ Do not use sharp objects to remove packaging materials to

avoid scratching surfaces.

■ The metal parts can be damaged if they are dropped.

■ Cordless drill, ¹⁄₈" bit

■ Phillips screwdriver

■ Flat-blade screwdriver

■ Socket drive #2 bits

■ Torx

®†

T25 screwdriver

■ Carpenter’s level

■ Tape measure

■ Tape (masking or

painters)

26¹⁄₂"

(67.3 cm)

¹⁄₂"

(189.2 cm)

¹⁄₈"

(157.8 cm)

†®TORX is a registered trademark of Saturn Fasteners, Inc.

Description (Quantity)

Stainless Steel

Part Number

White Part

Number

A. Top Trim Mount (1)

B. Top Grille (6) (shown

assembled)

C. Top Trim Notched Grille (1)

D. Top Plate (1)

E. Left-Hand Side Trim (1)

F. Gap Filler (1)

G. Right-Hand Side Trim (1)

H. Bottom Grille Assembly (1)

I. Rear spacer (2)

W10682840

W10682846

W10682843

W10682876

W10682850

W10682856

W10682853

W10682833

W10682858

W10682841

W10682847

W10682844

W10682875

W10682851

W10682857

W10682854

W10682834

W10682858