ELECTRIC BUILT-IN OVEN 24” SINGLE CAVITY MODELS ‘.._~~ (STARTING \ WITH 1982 MODELS) Part No. 311435 Rev.
SUPPORT JUNCTION SEENOTE 1 SURFA BOX: ’ *FOR A 36” OPEN OVEN DOOR HEIGHT FIGURE 1 --ROUGH-IN DIMENSIONS DO NOT INSTALL THIS OVEN IN A BASE CABINET WITH A COUNTERTOP ABOVE IT. 1. CARPENTRY NOTE: Wire sizes and connections must conform with the fuse size and rate of the appliance in accordance with the National Electrical Code and local codes and ordinances. Do not use an extension cord. Refer to Figure 1 for the dimensions of the oven and the space necessary to receive the oven.
If local codes permit connection of the frame grounding conductor to the neutral (white wire), connect the green and white wire from the supply cable of the appliance together and to the neutral (white) wire in the junction box. Connect the remaining wires from the supply cable. matching the colors, to the wires in the junction box. If local codes DO NOT permit frame grounding to the neutral, separate the white and green wires that extend out of the end of the supply cable of the appliance.
DOOR ADJUSTMENT (IF NEEDED) 4. Open oven door and loosen the upper adjustrng (seeview e) on the srde that needs adjustment. Close oven Adjust door door Fietlghten Open screw. oven Close oven alignment loosen dnd up and down the lower door door and lower adjusting CAUTION: Do not touch the element& be hot and you may get burned. screw Preheat ~ Turn selector switch to PREHEAT and set the thermostat to 350’ BAKE temperature.
