UNDERCOUNTER DISH WASHER Use & Care Guide
Table Of Contents
- you are responsible for
- table of contents
- important safety instructions
- energy saving tips
- using your dishwasher
- before starting your dishwasher
- starting your dishwasher
- cycles and options (models with one cycle)
- cycles and options (models with three cycles)
- cycles and options (models with three buttons)
- cycles and options (models with five buttons)
- cycles and options (models with seven buttons)
- to add a dish after starting
- changing a setting
- proper loading
- adding detergent
- using rinse agent
- for best results
- dishwasher care and cleaning
- common dishwashing problems
- before you call for service
- warranty
PROBLEM
Bronze tamish on silverplate
CAUSED BY
SOLUTION
Silverplate is worn off. Exposed base Remove tarnish with silver polish.
metal takes on a bronzed hue Have silver replated.
Water left in bottom of
dishwasher
Dishwasher cycle not completed
Allow dishwasher to complete cycle.
Some remaining water is normal and
keeps seals from drying.
Clogged drain air gap
Some plumbing codes require use of a
drain air gap between an under-
counter dishwasher end the drain
system of the house. The air gap is
usually located above the sink or on
the top of the counter near the
dishwasher to prevent the possibility
of water backing up from the dram
into the dishwasher due to a plugged
drain. The drain air gap is NOT a part
of the dishwasher and is NOT covered
by the dishwasher warranty. The
dram air gap should be kept clean to
ensure proper draining of the
dishwasher.
Page 14