Instruction for Use

21
TROUBLESHOOTING GUIDE
The oven does not work:
•
Check the mains power and that the oven is
electrically connected.
•
Turn the oven off and then on again to see if the
fault has been eliminated.
IMPORTANT:
•
Make sure the oven selector is not set to “0”
or on the “lamp” symbol .
- If the electronic programmer (if provided)
indicates “ ”, consult the separate
product sheet and/or the electronic
programmer description.
- If the electronic programmer (if provided)
indicates “
F XX
”, contact the nearest After-
Sales Service. In this case specify the number
after the letter “F”.
- Make sure the mechanical programmer
(if provided) is set to “manual”.
AFTER-SALES SERVICE
Before calling the After-Sales Service:
1.
Try to eliminate the problem on your own,
according to the points described in
“Troubleshooting Guide”.
2.
Switch the appliance off and then on again
to see if the problem has been eliminated.
If the fault persists after the above checks,
contact the nearest After-Sales Service.
Always specify:
•
a brief description of the fault;
•
the exact oven model and type;
•
the After-Sales Service number (number after
the word Service on the dataplate), located on
the right inside edge of the oven compartment
(visible when the door is open). The After-
Sales Service number is also given in the
warranty booklet;
•
your full address;
•
your telephone number.
If any repairs are required, contact an
authorised
Technical Service Centre
(to guarantee the
use of original spare parts and correct repair).
Failure to comply with these instructions
can compromise the safety and quality of
the product.
DECLARATION OF CONFORMITY
• This oven is intended to come into contact
with food products and complies with
European Regulation no. 1935/2004.
• It is designed to be used only as a cooking
appliance.
Any other use (e.g. for room heating)
is considered improper and therefore
potentially dangerous.
• This appliance has been designed,
manufactured and put on the market
in compliance with:
- the safety requirements of “Low Voltage”
Directive 2006/95/EC (replacing 73/23
EEC amended)
- the protection requirements of EMC
Directive 89/336/EEC
- the requirements of Directive 93/68/EEC.
61055024GB.fm Page 21 Monday, May 5, 2008 3:55 PM