Part No 759105-u --. I __.
Before you start... Check the locatIon where the ice make1 WIII be installed The location must provide. - Easy access to electrrclty and draInage lines . Protection from wind. weather. drIppIng or sprayng water, and other harmful elements l Protection from cold temperatures to prevent the water inlet valve and drain from freezing. .
Water requirements The cold water requires l/4.-0 tubing. NOTE: line to the ice maker D. soft copper A threaded compression fitting to connect the water line to the inlet valve is I” the parts bag Do Not discard shunt. The shunt must be reattached to the ice maker when the Ice maker is operated without a drain pump. See Installation Instructions included with drain pump.
17 Take CI few minutes to read the “Ice maker operation” section, Panel C, and Use and Core Guide to fully understand your new ice maker. Ice maker operation n the Before running your rce maker for the frrst time, you should note the followinQ * Water enters only durrng the defrost cycle, so the first harvest cycle ~111 be completed without water in the system.
Wiring diagram If you need assistance... The compressor will remain running until the bin thermostat becomes satisfied and opens up. This de-energizes all the system except for the transformer. cutter grid. and glacial Ice water pump This appliance operates at 115 volts, except for the cutter Qrld circuit and glaclol ice water pump.