Instruction for Use

30
GB
! If the oven is too hot, the pyrolytic cycle may not start.
Wait for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the button.
2. The display will show the text “Piro”, “nor” and the default
duration of 1:30 h (normal cycle) alternately.
3. Press button , then turn the TIMER knob to adjust the
default cleaning level. There are 3 different levels to choose
from, each with a pre-set duration which cannot be modied:
1. Economy (ECO): turn the knob towards “ ”. Duration
1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30
minutes.
3. Intensive (INT): turn the knob towards “ ”. Duration 2
hours.
4. Press the button to conrm.
5. Press the button to begin the cleaning cycle.
An end time for the FAST CLEAN cycle (as for a normal
cooking cycle) may be programmed (see Programming the
automatic cleaning end time).
Safety devices
• the door locks automatically as soon as the temperature
reaches a high value; the icon lights up on the display;
• pressing the button cancels the cleaning cycle t any
time;
• if a malfunction occurs, the heating elements will be
switched off;
• once the oven door has been locked, you cannot change
the duration and end time settings.
Problem Possible cause Solution
The appliance has just been
connected to the electricity
mains or there has been a blacko
u
Set the clock.
A programmed cooking mode
does not start.
There has been a blackout. Reprogram the cooking mode.
Only the high luminosity
“Clock button” is lit.
The appliance is in standby mode Press any button to exit
standby mode.
An automatic mode has been
selected. “Hot” appears on the
dis
p
la
y
and cookin
g
does not star
t
The temperature inside the oven
is higher than the suggested valu
e
for the selected mode.
Wait for the oven to cool down.
Fan-assisted cooking has been
selected and the food looks burnt.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
We recommend switching
dripping pan positions halfway
through cooking.
The “Clock button” and the
digits on the display flash.
Programming the automatic cleaning end time
1. Press the button twice: the icon and the
numerical digits on the display will begin to ash.
2. Turn the TIMER knob towards “ ” and “ ” to adjust the
cleaning end time value.
3. Once you have reached the desired end time, press the
button again. The display will show the duration, the
cleaning end time and the set cleaning level alternately.
4. Press the button to activate the programmed mode.
Programming has been set when the and buttons
are illuminated.
5. Once cleaning has nished, “END” appears on the display
and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO)
FAST CLEAN level has been selected, with the default
duration of 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30 a.m.
To cancel programming press the button.
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait
for the icon to switch off: this indicates the oven
temperature has dropped to an acceptable level. You will
notice some white dust deposits on the bottom and the sides
of your oven; remove these deposits with a damp sponge
once the oven has cooled down completely. Alternatively,
you can make use of the already heated oven, in which
case it is not necessary to remove the deposits, they are
completely harmless and will not affect your food in any way.
Troubleshooting